The world first 1-2S Brushless F3 flight controller with internal 4in1 ESC OSD 2.4G receiver Current sensor Buck / Booster is coming. You only need to add a VTX and Camera . It’s a best choice for 2S Brushless tiny whoop.
Flight controller | CRAZYBEEF3 PRO FS Firmware target: CrazybeeF3FS MCU: STM32F303CCT6 (72MHZ, 256K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Weight:4.2g Power supply: 1-2S battery input (DC 3.5-8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in Current meter Max 28A Current meter scale set to 1175 Built-in 5V 1A Buck / Boost with LC filter Built-in voltage detection BLHELI_S pass-through Ready Heading LED Ready Receiver options: SPI Frsky/ SPI Flysky / Serial DSM2 DSMX |
Onboard 4in1 ESC | MCU upgraded to EFM8BB21 Power supply: 1-2S LiPo/LiPo HV (3.5v/8.7v) Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.Hex Default protocol: DSHOT600 |
Built-in Flysky receiver |
SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 300m Failsafe support |
Built-in Frsky NON-EU receiver |
SPI BUS receiver Frsky D8/D16 switchable Compatible Non EU transmitter both D8 and D16 mode Channels: 8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m |
Built-in DSM2/DSMX receiverr |
Serial bus receiver Protocol: DSM2/DSMX compatible Channels:6-9 (Depend on your radio) No ground interference ( Transmitter and receiver 1 m from the ground): 300m |
不知道怎麼品管的,2S電池DC2DC到5V,400mA不到就燒IC,規格不是可到1A
hy guys i have 3 fc f3 pro stop working work with the usb but not with the lipo pad and its not about a crash they just stop working im a bit tired of those board and now they dont whant refund me whats happen with those board any solution for me i bought 2 mobula7 full kit and 4 fc to do my own build and now 3 board down please help me with this
Un cordial saludo
Hace alrededor de dos meses compré un controlador de vuelo F3 FS Pro y no fue bien en ningún momento …tengo problemas de rango y unas oscilaciones muy molestas cuando hago FPV …se pueden solucionar con una actualización del firmware o es defectuoso el producto
Gracias por adelantado y su atención .
Donde puedo encontrar el Firmware de la F3Pro version de FRSky o de XM+?
Desde Betaflight o GitHub ya no se encuentra disponible!
Where can i found firmware for F3Pro FrSky version or XM+ versión?
I can’t download from Betaflight or Github!