The BeecoreX is a ultimate flight controller for Brushed Tinywhoop , it include F4 FC, vtx , ESC, frsky receiver and betaflight OSD. It makes very easy to build a brushed tinywhoop. You only need to buy an FPV camera and brushed motors ,frame and propeller and then plug and play , No soldering require at all .
| Flight controller | (Frsky SPI RX version) Betaflight Firmware target: CrazybeeF4FR MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1S battery input (DC 2.9V-4.35V) Built-in 5A(each) Brushed 4in1 ESC Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX 25mw~100mw switchable Built-in SPI Frsky receiver(compatible with Frsky_D/ Frsky_X/ S-FHSS/ Redpine protocol) Built-in 5V 1A BEC Built-in voltage detection |
| Onboard Frsky SPI receiver Version | SPI BUS receiver Frsky version Compatible with Frsky D8/D16 ( D8 is recommend) , S-FHSS , Redpine protocol Channels: 8ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m RSSI compatible |
| Onboard 5.8g VTX | Output power: 25mw~100mw switchable Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels With Race band Smartaudio ready VTX POWER=1 (25mw) VTX POWER=2(50mw) VTX POWER=3(100mw) Recommend to use 50mw Recoomend Runcam Nano3 camera , plug and play |
Notes:
R1(RX1) Pad is used for IBUS/DSM2/DSMX signal input
IR1(IRX1) Pad is used for SBUS signal input (Already inverted)
R1 and IR1 Cannot be used simultaneously
In beta flight should I use FRSKY_X or FRSKY_X_V2? I can get it to bind only with X_V2 – is this an ACCST v1 versus v2 issue?