First please make sure your RXSR receiver has flashed the correct F.Port PROTOCOL FIRMWARE , download from https://www.frsky-rc.com/r-xsr/ Connection diagram(Please careful weld since the tiny soldering pin) Betaflight setup: Enable Serial RX for UART2 and select Serial-based receiver for the Receiver Mode, then choose Frsky FPort in the tab list from Serial Receiver provider. Don’t…
Weld the signal pin of the ibus or dsm2/dsmx receiver to RX1 pad of the flight controller. Enable Serial_RX for UART1 and VTX(TBS_Smartaudio for UART2) ,then choose the serial-based receiver for receiver mode in the configuration of Betaflight, and then choose the correct receiver provider based on your receiver brand .
New Crazybee F4 V3.0 Frsky New Crazybee F4 V3.0 Flysky
Larva X Frsky D8 version manual Larva X Flysky version manual Larva X Frsky Rxsr version manual Larva X Tbs crsf version manual Larva X old DSMX version(SP09X receiver) manual Larva X Frsky XM+ version manual Larva X new DSMX version(SPeki+ receiver) manual