NTSC_Auto_Recording_Non_split_20190713
This firmware is disable split the video every 2 minute , video output format is NTSC
NTSC_Auto_Recording_Split2minutes_20190715
This firmware is support video split the video to every 2 minute , video output format is NTSC
PAL_Auto_Recording_Split2minutes_20190715
This firmware is support video split the video to every 2 minute , video output format is PAL
PAL_Auto_Recording_Non_split_20190910
This firmware is disable split the video every 2 minute , video output format is PAL
Firmware update steps:
1. Download the firmware and Extract the “CRESFW.BIN” to an empty TF-SD card
2. Insert the TF-SD card to the slot of the Diamond_vtx ,then powering the Diamond_vtx
3.The Red LED will starting to blinking ,that means the firmware is in updating
4. When the Red LED turned off ,it means update successfully , then disconnect the power immediately once finished
5.Remember to delete the “CRESFW.BIN” after update successfully
Note: Don’t rename the firmware when copy to the TF-Card and Don’t disconnect the power while firmware updating .
Is there a firmware with default vtx_power 200mw? Unfortunately I can’t connect the VTX to any FC currently, and I’d like to know if there’s any other way to set the vtx power to 200mw.
Could you share a be a version of the firmware that defaults to 200mw instead of 25mw?
Thanks.
After updating the firmware to NTSC_Auto_Recording_Non_split_20190713, loading the VTX table in BF and unlocking the DVR I can turn the power ON/OFF but while I get “513” when I power OFF, when I power ON I get “444” the white LED does not flash and it does not record. Pressing the DVR button also does not start recording. What does “444” indicate?