| (Frsky version) CRAZYBEE F4FR PRO V3.0 Firmware target: CrazybeeF4FR (Flysky version) CRAZYBEE F4FS PRO V3.0 Firmware target: CrazybeeF4FS (No RX version) CRAZYBEE F4 PRO V3.0 Firmware target: CrazybeeF4DX MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 2-4S battery input (DC 7-17V) Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable) Flysky version Built-in SPI Flysky receiver with telemetry(AFHDS/AFHDS2A switchable) No RX version need to add external Receiver Built-in Betaflight OSD(SPI Control) Built-in Current meter Max 70A Current meter scale set to 470 Built-in 5V 1A BEC Built-in voltage detection |
| MCU upgraded to EFM8BB21 Power supply: 2-4S LiPo/LiPo HV (7v/17v) Current: 10A continuous peak 12A (5 seconds) Support BLHeliSuite programmable Factory firmware: F_H_40_REV16_5.HEX Default protocol: DSHOT600 |
| SPI BUS receiver Frsky D8/D16 switchable Compatible Non EU transmitter both D8 and D16 mode Channels: 8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m |
| SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 300m Failsafe support |
| No RX version support external serial-bus receiver like XM+, crossfire, S-FHSS etc. |
Recommend Battery: 2S 450mah/550mah , 3S 300mah/350mah/450mah, 4S 300mah/350mah
Notes: If used 3inch propellers, we recommend use 2-3S only
I just flew 3 packs, and the quad get to the ground, on betafligth it gets a flag of “no_gyro”. It’s so sad to buy something, wait for 2 months to arrive, and can’t enjoy it. maybe, my experience can help to improve this artifact.
Bought my mobula 7 hd had it maybe a week before the esc burnt out. Very disappointed. Been out of flight for 7 months trying to find a flight controller for the model. Just wish I could fly it after paying $150 for the drone.
（Frskyバージョン）CRAZYBEE F4FR PRO V3.0ファームウェアターゲット：CrazybeeF4FR
SMART AUDIOはどこに接続しますか？
Hello, is it possible to bind the Crazybee F4 PRO V3.0 Frsky version with a Frsky Taranis Q X7 LBT version?
only one day after arrival a minor bump to a wall I ripped of the TX2 pad. Unfortunately impossible to repair. Also I cannot find any source for a new “Crazybee F4 Pro V3.0 no RX version” FC. How can I get this spare part? Please answer!