CrazybeeX series flight controller is the first 4in1 AIO flight controller which could handle 2s.
The CrazybeeX DXS V1.0 is the newest member which is the first flight controller built-in DSM2/DSMX compatible SPI Receiver.
It’s a better upgrade for reduce the weight of your brushless whoop if you are using Spektrum transmitter. Best upgrade flight controller for Mobula6/Mobula6HD DSMX version .
| Flight controller | MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1S-2S battery input (DC 2.9V-8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX Built-in SPI Frsky receiver support D8/D16 Built-in 5V 1A BEC Built-in voltage detection Firmware version Customized Betaflight4.3.0 S411 |
| Onboard 4in1 ESC | MCU upgraded to EFM8BB21 Power supply: 1-2S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.HEX Default protocol: DSHOT600 |
| Onboard DSM2/DSMX SPI receiver | SPI BUS receiver DSM2/DSMX compatible Channels: Max 12ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m RSSI enable(show on the goggles) |
| Onboard 5.8g VTX | Output power: 25mw~200mw switchable Frequency: 40CH Input voltage: 3.3V~5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels With Race band Smartaudio ready Default vtx_power should set to be “3” |
| Onboard Voltage and Current detector | Voltage Meter scale “110” Amperage Mete scale “1175” |
Notice: Recommend Betaflight configurator 10.7.0 version
SPI Receiver option: Spektrum
Bind procedure:
- Plug the USB then press the bind button, the red LED at the bottom of the flight controller will blinking fast , this indicate the SPI DSM2/DSMX receiver is in bind mode.
- Plug the USB then connect to Betaflight configurator, move to the CLI tab , then type “bind_rx”, the red LED at the bottom of the flight controller will blinking fast too , this indicate the SPI DSM2/DSMX receiver is in bind mode.
Firmware download:
Where can I buy this FC. mine burnt out. Please help. I need a replacement ASAP.